VSRB1060MS-3WB

1. The steel shaft of the steel belt (series/disc) station is an elastic structure, which flexibly fits the end of the workpiece and runs at high speed to cut the slag and make the slag break and fall off; compared with the traditional belt sanding method, the slag removal is more thorough and clean, the cost of consumables is less than one tenth, and it is more energy-saving and environmental friendly; the belt runs at high speed through the elastic pressure wheel to fit the end of the workpiece to remove the fast mouth burr, and the belt flexibly touches the workpiece to reduce The abrasive belt is flexible to contact the workpiece to reduce the loss of abrasive belt;

2. The abrasive block is made of flexible material, which is flexible and runs at high speed against the workpiece end face to cut the workpiece fast-ported edges, and the soft abrasive block can reach into the workpiece groove hole to remove the inward burr and chamfer.

The equipment is developed and manufactured by Wanchuang independently, and Wanchuang has full independent intellectual property rights, the whole machine has been authorized to patent, and imitation is prohibited.

Applicable Scope：Flame (plasma) cutting of medium-thick steel sheet metal workpieces for de-slagging, deburring and chamfering.

VSRB1060MS-3WB：Three stations combined structure. The first station conveyor belt upper steel shaft brush plate, remove the upper end surface of the steel plate cutting slag, the second station a set of flexible sanding belt, remove the upper end surface of the steel plate flanging burr, the third station a set of abrasive belt, the upper end surface of the steel plate sharp angle grinding friction chamfering; belt conveyor, conveyor speed 1-5m/min frequency adjustable; total power 28kw, total weight 3.5T, length, width and height 2800m m * 1800 * 2200m m; maximum processing width 1050m m, minimum processing 100*50mm, can be customized to the widest 2500mm machine.

General technology, parameters：Control system (human-machine interface, PLC programming control, one key to start and stop the equipment); grinding head speed (500-1000R/min), conveying speed (1-5m/min frequency adjustable); power supply voltage (three-phase five-wire, 380V, 50Hz); grinding head automatic lifting and positioning workpiece thickness, automatic compensation of abrasive loss, positioning thickness O-80mm adjustable.

The equipment supports customization and can be customized with other specifications.